Mb Front Unit Removal - Epson Stylus Pro 5000 Service Manual

Stylus Pro5000
9. Remove FFC inserted in each right and left head, and remove the print
head. (Refer to Figure4-22)
T T
9
CHECK POINT
When replacing heads to new ones, connect
FFC correctly. Only the FFC which should be
installed for left head is marked with "O".
$'-8670(17
After replacing the print head, refer to Table5-1 of
Chapter5, and perform necessary adjustment
items according to the procedure order.
"O" is marked only on the FFC for lleft head
Left Head
(for dark colors)
Figure 4-22. Print Head Removal(2)
Rev.A
Right Head
(for light colors)

4.2.5.4 MB Front Unit Removal

1. Remove the mechanism unit.(Refer to section 4.2.7)
2. Remove one CBS screw(3x6) securing "Grounding plate, DB2" to
"Shield plate, M/B, Front".
3. Remove one CBS screw(3x6) securing "Grounding plate, DB2" to
"Frame Assembly, Left".
4. Remove "Grounding plate, DB2". (Refer to Figure4-23)
"Frame Assembly, Left"
"Grounding Plate, DB2"
Figure 4-23. Grounding Plate, DB2 Removal
Chapter4 Assembly and Disassembly
2 CBS screws(3x6)
"Shield Plate, M/B, Front"
4-13