Removing The Manual Pickup Feed Solenoid; Manual Separation Roller; Removing The Cassettes; Removing The Rear Cover - Canon MF8100 Series Service Manual

3) Disconnect the 3 connectors [1], and remove the 8 screws [2]; then, detach
the main drive assembly [3].
[1]
[2]
[3]

3.6.7.13 Removing the Manual Pickup Feed Solenoid

1) Disconnect the 2 connectors [1], and free the harness [2] from the harness
guide [3].
2) Free the cable [1] of the density detection board and the ITB home
position detection board from the harness guide [2]: then, free the cable
from the clamp of the pickup solenoid cover [3].
3) Remove the screw [4], and detach the pickup solenoid cover [5].
[1]
[3]
[4]
[2]
4) Disconnect the connector [1], and remove the screw [2]; then, detach the
manual feed pickup solenoid [3].
[2]
[3]
[2]
[1]
[1]
[2]
F-3-929
[5]
F-3-930
[1]
F-3-931

3.6.8 Manual Separation Roller

3.6.8.1 Removing the Cassettes

1) Hold the grip, and take out the cassette.

3.6.8.2 Removing the Rear Cover

1) Disconnect the cable [1] of the power supply assembly.
2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.
[3]
3) Open the reader assembly [4], and lift to free the 2 claws [5].
0007-7128
4) Close the reader assembly; then, detach the rear cover[1].
[3]
F-3-934
3.6.8.3 Removing the Right Cover (with the reader
assembly intact)
1) Free the cable [1] of the reader assembly.
Chapter 3
[1]
[3]
[2]
F-3-932
[4]
[5]
F-3-933
[1]
[3]
[2]
0007-8510
0007-8511
0007-8512
3-143