Dell Networking 2024 Reference Manual page 733

vlan-range — VLANs to be added to the existing MST instance. To specify
•
a range of VLANs, use a hyphen. To specify a series of VLANs, use a
comma. (Range: 1-4093)
Default Configuration
VLANs are mapped to the common and internal spanning tree (CIST)
instance (instance 0).
Command Mode
MST mode
User Guidelines
Before mapping VLANs to an instance use the spanning-tree mst enable
command to enable the instance.
All VLANs that are not explicitly mapped to an MST instance are mapped to
the common and internal spanning tree (CIST) instance (instance 0) and
cannot be unmapped from the CIST.
For two or more switches to be in the same MST region, they must have the
same VLAN mapping, the same configuration revision number, and the same
name.
Dell Networking MSTP supports mapping of VLANs to MST instances, even
though the underlying VLAN may not be defined on the switch. Traffic
received on VLANs not defined on the port received is dropped.
Example
The following example maps the entire range of VLANs to MST instances
(MST instance 0 is mapped to VLAN 1 by default). Additionally, two 10G
ports have some, but not all, of the VLANs mapped to MST instances.
console(config)#spanning-tree mode mst
console(config)#spanning-tree mst 1 priority 8192
console(config)#spanning-tree mst 2 priority 28672
console(config)#spanning-tree mst configuration
console(config-mst)#instance 1 add vlan 2-199
console(config-mst)#instance 1 add vlan 350
console(config-mst)#instance 1 add vlan 400-449
console(config-mst)#instance 1 add vlan 500-1999
console(config-mst)#instance 1 add vlan 2200-2499
Spanning Tree Commands
733