Clear Ipv6 Statistics; Ipv6 Address - Dell Networking 2024 Reference Manual

Example
The following example clears all entries in the IPv6 neighbor table.
console(config)#clear ipv6 neighbors

clear ipv6 statistics

Use the clear ipv6 statistics command in Privileged EXEC mode to clear IPv6
statistics for all interfaces or for a specific interface, including loopback and
tunnel interfaces. IPv6 statistics display in the output of the show ipv6 traffic
command.
Syntax
clear ipv6 statistics [vlan
vlan-id — Valid VLAN ID.
•
tunnel-id — Tunnel identifier. (Range: 0-7)
•
loopback-id — Loopback identifier. (Range: 0-7)
•
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Example
The following example clears IPv6 statistics for VLAN 11.
console(config)#clear ipv6 statistics vlan 11

ipv6 address

Use the ipv6 address command in Interface Configuration mode to configure
an IPv6 address on an interface (including tunnel and loopback interfaces)
and to enable IPv6 processing on this interface. Multiple globally reachable
vlan-id
| tunnel
tunnel-id
| loopback
IPv6 Routing Commands
loopback-id
]
1083