Dell Networking 2024 Reference Manual page 1210

Example
The following example configures the authentication type and key for the
area 10 OSPF virtual interface and neighbor ID.
console(config-router)#area 10 virtual-link 192.168.2.7 authentication
console(config-router)#area 10 virtual-link 192.168.2.7 authentication
encrypt test123 1001010
area virtual-link dead-interval
Use the area virtual-link dead-interval command in Router OSPF
Configuration mode to configure the dead interval for the OSPF virtual
interface on the virtual interface identified by area-id and neighbor router.
Use the no form of the command to return the dead interval to the default
value.
Syntax
area-id
area virtual-link
area-id
no area
area-id — Identifies the OSPF area to configure. (Range: IP address or
•
decimal from 0–4294967295)
neighbor-id — Identifies the Router ID of the neighbor.
•
seconds — Number of seconds to wait before the OSPF virtual interface
•
on the virtual interface is assumed to be dead. (Range: 1–2147483647)
Default Configuration
40 seconds is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
1210
OSPF Commands
neighbor-id
neighbor-id
virtual-link
seconds
dead-interval
dead-interval