Dell Networking 2024 Reference Manual page 394

Syntax
show interfaces status
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
Port channels are only displayed if configured. Use the
channel command to display configured and unconfigured port channels.
Interfaces configured as stacking ports will show as detached in the output of
the show interfaces status
The link state indicates the physical connectivity state of the link. It is
possible that the link is connected physically yet frames are not able to pass
over the link. Possible causes of this condition are speed or duplex mismatch.
The displayed port status information includes the following:
Field
Port
Description
Duplex
VLAN
Speed
Neg
Link State
Flow Ctrl
Status
Example
The following example displays the status for all configured interfaces.
394
Ethernet Configuration Commands
command.
Description
The port or port channel number. Oob means Out-of-Band
Management Interface.
Description of the port.
Displays the port Duplex status.
The native VLAN for the port.
Refers to the port speed.
Describes the Auto-negotiation status.
Displays the Link status, either Up or Down.
Displays the Flow Control status, either Active or Inactive.
show interfaces port-