Ipv6 Enable - Dell Networking 2024 Reference Manual

Example
The following example configures an IPv6 address and enables IPv6
processing.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 address 2020:1::1/64

ipv6 enable

Use the ipv6 enable command in Interface Configuration mode to enable
IPv6 routing on an interface (including tunnel and loopback interfaces) that
has not been configured with an explicit IPv6 address. Command execution
automatically configures the interface with a link-local address. The
command is not required if an IPv6 global address is configured on the
interface.
Syntax
ipv6 enable
no ipv6 enable
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables IPv6 routing, which has not been configured
with an explicit IPv6 address.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 enable
1085
IPv6 Routing Commands