Dell Networking 2024 Reference Manual page 1221

Default Configuration
The default preference value is 110 for dist1, dist2 and dist3.
Command Mode
Router OSPF Configuration mode.
Router OSPFv3 Configuration mode.
User Guidelines
There are no user guidelines for this command.
Examples
The following examples set route preference values of OSPF in the router.
console(config-router)#distance ospf intra 4
console(config-router)#distance ospf type1 19
distribute-list out
Use the distribute-list out command in Router OSPF Configuration mode to
specify the access list to filter routes received from the source protocol. Use
the no form of the command to remove the specified source protocol from
the access list.
Syntax
name
distribute-list
no distribute-list
name —The name used to identify an existing ACL. The range is 1–31
•
characters.
• rip—Apply the specified access list when RIP is the source protocol.
• static—Apply the specified access list when packets come through the
static route.
• connected—Apply the specified access list when packets come from a
directly connected route.
out {rip | static
name
out {rip | static
\
connected}
\
connected}
OSPF Commands
1221