Show Ipv6 Mld Groups - Dell Networking 2024 Reference Manual

show ipv6 mld groups

The show ipv6 mld groups command is used to display information about
multicast groups that MLD reported. The information is displayed only when
MLD is enabled on at least one interface. If MLD was not enabled on any
interfaces, there is no group information to be displayed.
Syntax
show ipv6 mld groups {
group-address — The group address to display.
•
vlan-id — A valid VLAN id.
•
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
The following fields are displayed as a table when vlan
Field
Number of (*, G)
entries
Number of (S, G)
entries
Group Address
Interface
Uptime
Expiry Time
group-address
Description
Displays the number of groups present in the MLD Table.
Displays the number of include and exclude mode sources
present in the MLD Table.
The address of the multicast group.
Interface through which the multicast group is reachable.
Time elapsed in seconds since the multicast group has been
known.
Time left in seconds before the entry is removed from the
MLD membership table.
vlan-id
| vlan }
vlan-id
IPv6 Routing Commands
is specified:
1111