Ipv6 Mld Snooping Querier Query-Interval - Dell Networking 2024 Reference Manual

enabled, if the Snooping Querier finds that the other Querier's source address
is numerically lower than the Snooping Querier's address, it stops sending
periodic queries. If the Snooping Querier wins the election then it will
continue sending periodic queries. Use the no form of this command to
disable election participation on a VLAN.
Syntax
vlan-id
ipv6 mld snooping querier election participate
vlan-id
no ipv6 mld snooping querier election participate
vlan-id — A valid VLAN ID. (Range: 1 - 4093)
•
Default Configuration
Election participation is disabled by default.
Command Mode
Global Configuration mode
User Guidelines
If there is another querier in the network and the local querier is in election
mode, then the querier with the lower IP address is elected and the other
querier stops querying. If the local querier is not in election mode and
another querier is detected, the local querier stops querying.
Example
console(config-vlan)#ipv6 mld snooping querier election participate 10

ipv6 mld snooping querier query-interval

Use the ipv6 mld snooping querier query-interval command to set the MLD
Querier Query Interval time. It is the amount of time in seconds that the
switch waits before sending another general query. Use the no form of this
command to reset the Query Interval to the default.
Syntax
interval
ipv6 mld snooping querier query-interval
ipv6 mld snooping querier query-interval
524
IPv6 MLD Snooping Querier Commands