Dell Networking 2024 Reference Manual page 499

icmp-type
type
[icmp-code
[routing] [fragments] [dscp
unit/slot/port
| redirect}
{deny | permit}–Specifies whether the IP ACL rule permits or denies the
•
matching traffic.
ipv6-protocol
• {
ACL rule.
– IPv4 protocols:
Every: Match any protocol (don't care)
–
source-ipv6-prefix /prefixlength | any | host src-ipv6-address —Specifies a
•
source IP address and netmask to match for the IP ACL rule.
– For IPv6 ACLs, "any" implies a 0::/128 prefix and a mask of all ones.
– Specifying "host X::X" implies a prefix length as "/128" and a mask of
0::/128.
portkey | startport } { portkey | endport } | {eq | neq | lt | gt}
• [{range {
portkey | 0-65535 }]—Specifies the layer 4 destination port match
{
condition for the IP/TCp/UDP ACL rule. A destination port number,
which ranges from 0-65535, can be entered, or a
of the following keywords: bgp, domain, echo, ftp, ftp-data, http, ntp,
pop2, pop3, rip, smtp, snmp, telnet, tftp, telnet, time, who and www. Each
of these keywords translates into its equivalent destination port number.
– When "range" is specified, IPv6 ACL rule matches only if the layer 4
port number falls within the specified portrange. The
endport parameters identify the first and last ports that are part of the
port range. They have values from 0 to 65535. The ending port must
have a value equal or greater than the starting port. The starting port,
ending port, and all ports in between will be part of the layer 4 port
range.
– When "eq" is specified, IPv6 ACL rule matches only if the layer 4 port
number is equal to the specified port number or portkey.
– When "lt" is specified, IPv6 ACL rule matches if the layer 4
destination port number is less than the specified port number or
portkey. It is equivalent to specifying the range as 0 to <specified port
number – 1>.
icmp-code
dscp
]}} [log] [assign-queue
] [rate-limit
number every
| | }—Specifies the protocol to match for the IP
icmpv6, ipv6, tcp and udp
] | icmp-message
rate burst-size
]
portkey , which can be one
IPv6 Access List Commands
icmp-message
]
queue-id
] [{mirror
startport and
499