Ping Ipv6 Interface - Dell Networking 2024 Reference Manual

• source—Use the specified source IP address, loopback address, VLAN
address, tunnel, or out-of-band interface address in the transmitted
packets
• loopback—Use the source address from the loopback port index.
• VLAN—The source VLAN over which to send the echo request.
• out-of-band—Sends the ping over the out-of-band interface.
Default Configuration
It is not possible to ping from a specific interface when a VLAN is specified as
the source of the ping. The system selects the first available interface in the
VLAN from which to send the ping packets.
Command Mode
User EXEC and Privileged EXEC modes
User Guidelines
This command has no user guidelines.s
Example
The following example determines whether another computer is on the
network at the IPv6 address specified.
console#ping ipv6 2030:1::1/64
Send count=3, Receive count=0 from 2030:1::1/64
Average round trip time = 0.00 ms

ping ipv6 interface

Use ping ipv6 interface command in the Privileged EXEC mode to
determine whether another computer is on the network. To use the
command, configure the switch for network (in-band) connection. The
source and target devices must have the ping utility enabled and running on
top of TCP/IP. The switch can be pinged from any IP workstation with which
the switch is connected through the default VLAN (VLAN 1), as long as there
is a physical path between the switch and the workstation. The terminal
IPv6 Routing Commands
1103