Dell Networking 2024 Reference Manual page 1067

User Guidelines
The command displays the following information.
Parameter
BGP Section:
Routing Protocol
Router ID
Local AS Number
BGP Admin Mode
Maximum Paths
Distance
Prefix List In
Prefix List Out
Neighbors
OSPFv2 Section
Routing Protocol
Router ID
OSPF Admin Mode Whether OSPF is enabled or disabled globally.
Maximum Paths
Routing for
Networks
Description
BGP.
The router ID configured for BGP.
The AS number that the local router is in.
Whether BGP is globally enabled or disabled.
The maximum number of next hops in an internal or external
BGP route.
The default administrative distance (or route preference) for
external, internal, and locally-originated BGP routes. The table
that follows lists ranges of neighbor addresses that have been
configured to override the default distance with a neighbor-
specific distance. If a neighbor's address falls within one of
these ranges, routes from that neighbor are assigned the
configured distance. If a prefix list is configured, then the
distance is only assigned to prefixes from the neighbor that are
permitted by the prefix list.
The global prefix list used to filter inbound routes from all
neighbors.
The global prefix list used to filter outbound routes to all
neighbors.
A list of configured neighbors and the inbound and outbound
policies configured for each.
OSPFv2.
The router ID configured for OSPFv2.
The maximum number of next hops in an OSPF route.
The address ranges configured with an OSPF network
command.
IP Routing Commands
1067