Ip Dhcp Snooping Log-Invalid - Dell Networking 2024 Reference Manual

range of 0-300 packets per second and the burst interval in the range of 1-15
seconds. In general, a rate limit of under 100 pps is valid for untrusted
interfaces.
Examples
console(config-if-Gi1/0/1)#ip dhcp snooping limit none
console(config-if-Gi1/0/1)#ip dhcp snooping limit rate 100 burst interval 1

ip dhcp snooping log-invalid

Use the ip dhcp snooping log-invalid command to enable logging of DHCP
messages filtered by the DHCP Snooping application. Use the no form of this
command to disable logging.
Syntax
ip dhcp snooping log-invalid
no ip dhcp snooping log-invalid
Default Configuration
Logging of filtered messages is disabled by default.
Invalid DHCP messages are not logged by default.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet,
fortygigabitethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-Gi1/0/1)#ip dhcp snooping log-invalid
console(config-if-Gi1/0/1)#no ip dhcp snooping log-invalid
336
DHCP Snooping Commands