Dell Networking 2024 Reference Manual page 327

Syntax
show dhcp lease [interface { out-of-band | vlan
• out-of-band—The out-of-band interface.
• vlan—The VLAN and VLAN ID.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC, Configuration mode and all Configuration submodes
User Guidelines
This command lists all IPv4 addresses currently leased from a DHCP server
on a routing interface. This command only applies to routing interfaces. To
see the IPv4 address leased on the out-of-band interface, use the command
show ip interface
This command output provides the following information.
Term
IP address, Subnet
mask
DHCP Lease server The IPv4 address of the DHCP server that leased the address.
State
DHCP transaction
id
Lease
Renewal
Rebind
Retry count
out-of-band.
Description
The IP address and network mask leased from the DHCP server.
State of the DHCPv4 Client on this interface.
The transaction ID of the DHCPv4 Client.
The time (in seconds) that the IP address was leased by the
server.
The time (in seconds) when the next DHCP renew Request is
sent by DHCPv4 Client to renew the leased IP address.
The time (in seconds) when the DHCP Rebind process starts.
Number of times the DHCPv4 client sends a DHCP
REQUEST message before the server responds.
DHCP Management Interface Commands
vlan-id
} ]
327