Ip Addressing Commands - Dell Networking 2024 Reference Manual

IP Addressing Commands

Dell Networking N2000/N3000/N4000 Series Switches
Interfaces on the Dell Networking switches support a variety of capabilities to
support management of the switch. In addition to performing switching and
routing of network traffic, Dell Networking switches act as a host for
management of the switch. Commands in this category allow the network
operator to configure the local host address, utilize the embedded DHCP
client to obtain an address, resolve names to addresses using DNS servers, and
detect address conflicts on the local subnet.
There are two management interface types on Dell Networking switches. In-
band interfaces allow management of the switch through the network
switching/routing interfaces. Out-of-band management is always through the
dedicated out-of-band interface. The serial port on the stack master provides
a direct console interface supporting a CLI. In-band management interfaces
can employ a variety of protection mechanisms including VLAN assignment
and Management ACLs. The out-of-band port does not support such
protection mechanisms and, therefore, it is recommended that the out-of-
band interface only be connected to a physically segregated management
network.
Commands in this Chapter
This chapter explains the following commands:
clear host
clear ip address-conflict-detect
ip address (Out-of-Band)
ip address-conflict-detect run
ip address dhcp (Interface Configuration) ipv6 enable (Interface Configuration)
ip default-gateway
ip domain-lookup
ip domain-name
ip host
ip name-server
ipv6 address (Interface Configuration)
ipv6 address dhcp
show hosts
show ip address-conflict
show ip helper-address
IP Addressing Commands
21
477