Dell Networking 2024 Reference Manual page 436

Syntax
show green-mode
interface-id
•
interface representation.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC
User Guidelines
This command output provides the following information.
Term
Energy-detect
admin mode
Energy-detect
operational status
Reason for Energy-
detect current
operational status
EEE Admin Mode
Rx Low Power Idle
Event Count
436
Green Ethernet Commands
interface-id
—Any valid interface. See
Description
Energy Detect
Energy-detect mode is enabled or disabled.
Energy detect mode is currently active or inactive. The energy
detect mode may be administratively enabled, but the
operational status may be inactive. The reasons for the
operational status are described below.
The energy detect mode may be administratively enabled, but
the operational status may be inactive. The possible reasons are:
Port is currently operating in the fiber mode
1
Link is up.
2
If the energy-detect operational status is active, then the reason
field shows up as:
No energy Detected
1
EEE Admin Mode is enabled or disabled.
This field is incremented each time MAC RX enters LP IDLE
state. Shows the total number of Rx LPI Events since EEE
counters are last cleared.
Interface Naming Conventions
EEE
for