Area Virtual-Link Authentication - Dell Networking 2024 Reference Manual

network 10.50.50.0 0.0.0.255 area 10
area 10.0.0.0 virtual-link 10.3.4.5 message-digest-key 100 md5 test123

area virtual-link authentication

Use the area virtual-link authentication command in Router OSPF
Configuration mode to configure the authentication type and key for the
OSPF virtual interface identified by the area ID and neighbor ID. Use the no
form of the command to return the authentication type to the default value.
Syntax
area-id
area virtual-link
key key-id
encrypt
area-id
no area virtual-link
area-id — Identifies the OSPF area to configure. (Range: IP address or
•
decimal from 0–4294967295)
neighbor-id — Identifies the Router identifier of the neighbor.
•
• encrypt — Use MD5 Encryption for an OSPF Virtual Link.
key — Authentication key for the specified interface. (Range: 8 bytes or
•
less if the authentication type is simple and 16 bytes or less if the type is
encrypt.)
key-id — Authentication key identifier for the authentication type
•
encrypt. (Range: 0–255)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
Unauthenticated interfaces cannot be configured with an authentication key.
If no parameters are specified after the authentication keyword, then plain-
text password authentication is used.
neighbor-id
]
neighbor-id
authentication [none | simple
authentication
OSPF Commands
key
|
1209