Mvr Vlan Group - Dell Networking 2024 Reference Manual

console(config-if-Gi1/0/1)#interface Gi1/0/24
console(config-if-Gi1/0/24)#switchport mode trunk
console(config-if-Gi1/0/24)#switchport trunk native vlan 99
console(config-if-Gi1/0/24)#switchport trunk allowed vlan add 99
console(config-if-Gi1/0/24)#mvr
console(config-if-Gi1/0/24)#mvr type source
console(config-if-Gi1/0/24)#exit

mvr vlan group

Use the mvr vlan group command in Interface Configuration mode to
participate in the specific MVR group. Use the no form of this command to
remove the port participation from the specific MVR group.
Syntax
mVLAN group A.B.C.D
mvr vlan
mVLAN group A.B.C.D
no mvr vlan
VLAN —The VLAN over which multicast data from the specified group is
•
to be received.
A.B.C.D. —The multicast group for which multicast data is to be received
•
over the specified VLAN.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration
User Guidelines
This command statically configures a port to receive the specified multicast
group on the specified VLAN. This command only applies to receiver ports in
compatible mode. It also applies to source ports in dynamic mode. In
dynamic mode, receiver ports can also join multicast groups using IGMP
messages.
Example
console(config-if-Gi1/0/1)#interface Te1/1/1
console(config-if-Gi1/0/24)#switchport mode trunk
582
Multicast VLAN Registration Commands