Dell Networking 2024 Reference Manual page 629

vlan-id — The source VLAN identifier. All the ports in this VLAN are
vlan
•
mirrored. The source VLAN must not be the RSPAN VLAN.
acl-name — An IP or MAC ACL name.
•
• remote vlan
• reflector-port
switch. It is required that the reflector port be configured as a trunk port or
otherwise have VLAN tagging enabled. The relector port cannot be a port
channel.
• rx — Monitors received packets only. If no option specified, monitors both
rx and tx.
tx — Monitors transmitted packets only. If no option is specified, monitors
•
both rx and tx.
• both—Monitors both ingress and egress. This is the default.
Default Configuration
The default is to monitor both transmit and receive directions. If neither tx or
rx is configured, both directions are monitored.
Command Mode
Global Configuration mode
User Guidelines
The source of a monitoring session must be configured before the destination
can be configured. Only one session with a single destination is supported,
however, that session supports multiple sources. The internal CPU port
cannot be configured as an RSPAN source.
Reserve a few VLANs across the network for the exclusive use of RSPAN. Do
not assign access ports to these VLANs. The source VLAN (if configured),
cannot be the same as the RSPAN VLAN. The destination interface must be
configured as a member of the RSPAN VLAN on the source switch. The
source interface must be configured as a member of the RSPAN VLAN on the
destination switch.If an ACL name is specified, the ACL must be created
prior to its use in an RSPAN configuration.
RSPAN VLANs must be configured with the remote-span command.
rspan-vlan-id — An RSPAN VLAN.
interface-id — Any physical interface on the destination
Port Monitor Commands
629