Syntax
pool-name
ip dhcp pool [
no ip dhcp pool [
pool-name —The name of an existing or new DHCP address pool. The
•
pool name can be up to 31 characters in length and can contain the
following characters: a-z, A-Z, 0-9, '-', '_', ' '. Enclose the entire pool name
in quotes if an embedded blank is to appear in the pool name.
Default Configuration
The command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This capability requires the DHCP service to be enabled. Enable the DHCP
service using the service dhcp command. Dell Networking supports dynamic,
automatic, and manual address assignment. Dynamic address assignment
leases an address to the client for a limited period of time. Automatic
assignment assigns a permanent address to a client. Manual (static)
assignment simply conveys an address assigned by the administrator to the
client.
In DHCP Pool Configuration mode, the administrator can configure the
address space and other parameters to be supplied to DHCP clients. By
default, the DHCP server assumes that all addresses specified are available for
assignment to clients. Use the
Configuration mode to specify addresses that should never be assigned to
DHCP clients.
To configure a dynamic DHCP address pool, configure the following pool
properties using the listed DHCP pool commands:
•
Address pool subnet and mask – network
•
Client domain name – domain-name
•
Client DNS server – dns-server
•
NetBIOS WINS Server – netbios-name-server
]
pool-name
]
ip dhcp excluded-address
DHCP Server and Relay Agent Commands
command in Global
933