Show Ip Route - Dell Networking 2024 Reference Manual

Default Route Advertise................... Disabled
Always.................................... FALSE
Metric.................................... Not configured
Metric Type............................... External Type 2
Redist
Source Metric
--------- -------
static default
connected
Number of Active Areas.................... 3 (3 normal, 0 stub, 0 nssa)
ABR Status................................ Yes
ASBR Status............................... Yes
Routing Protocol.......................... RIP
RIP Admin Mode............................ Enable
Split Horizon Mode........................ Simple
Default Metric............................ Not configured
Default Route Advertise................... Disable
Distance.................................. 120
Interface
---------
0/25

show ip route

Use the show ip route command in Privileged EXEC mode to display the
current state of the routing table. The output of the command also displays
the IPv4 address of the default gateway and the default route associated with
the gateway.
This command deprecates the show ip route configured and show ip route
connected commands.
Syntax
show ip route [ip-address [mask |
• ip-address—Specifies the network for which the route is to be displayed
and displays the best matching route for the address.
• mask—Subnet mask of the IP address.
1070
IP Routing Commands
Metric Type
-----------
10
Send
----
RIPv2
Subnets
-------
2 Yes
2 Yes
Recv
----
RIPv2
prefix-length
] [longer-prefixes] ]
Dist List
---------
None
1