Ipv6 Dhcp Snooping Binding - Dell Networking 2024 Reference Manual

Syntax
ipv6 dhcp snooping vlan
no ipv6 dhcp snooping
vlan-range —A single VLAN, one or more VLANs separated by commas, or
•
two VLANs separated by a single dash indicating all VLANs between the
first and second inclusive. Multiple VLAN identifiers can be entered
provided that no embedded spaces are contained within the
Default Configuration
By default, DHCP snooping is not enabled on any VLANs.
Command Modes
Global Configuration mode
User Guidelines
DHCP snooping must be enabled on at least one VLAN and globally enabled
to become operational.
Example
console(config)#ipv6 dhcp snooping
console(config)#ipv6 dhcp snooping vlan 5-10,15,30
console(config)#interface te1/0/1
console(config-if-te1/0/1)#switchport mode access
console(config-if-te1/0/1)#switchport access vlan 10
console(config-if-te1/0/1)#no ipv6 dhcp snooping trust

ipv6 dhcp snooping binding

Use the ipv6 dhcp snooping binding command to configure a static IPv6
DHCP snooping binding. Use the no form of the command to remove the
entry from the binding database.
Syntax
ipv6 dhcp snooping binding
{gigabitethernet
fortygigabitethernet
no ipv6 dhcp snooping binding
978
DHCPv6 Snooping Commands
vlan-range
vlan-range
mac-address
unit/slot/port
| tengigabitethernet
unit/slot/port
mac-address
vlan-id ip-address
vlan
port-channel-id
| port-channel
vlan-range .
interface
unit/slot/port
|
}