Ip Igmp Last-Member-Query-Count; Ip Igmp Last-Member-Query-Interval - Dell Networking 2024 Reference Manual

ip igmp last-member-query-count

Use the ip igmp last-member-query-count command in Interface
Configuration mode to set the number of Group-Specific Queries sent before
the router assumes that there are no local members on the interface.
Syntax
Imqc
ip igmp last-member-query-count
no ip igmp last-member-query-count
Imqc — Query count. (Range: 1-20)
•
Default Configuration
The default last member query count is 2.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets 10 as the number of VLAN 2 Group-Specific
Queries.
console#configure
console(config)#interface vlan 2
console(config-if-vlan2)#ip igmp last-member-query-count 10
console(config-if-vlan2)#no ip igmp last-member-query-count

ip igmp last-member-query-interval

Use the ip igmp last-member-query-interval command in Interface
Configuration mode to configure the Maximum Response Time inserted in
Group-Specific Queries which are sent in response to Leave Group messages.
Syntax
tenthsofseconds
ip igmp last-member-query-interval
1009
IGMP Commands