Dell Networking 2024 Reference Manual page 1206

area stub no-summary
Use the area stub no-summary command in Router OSPF Configuration
mode to prevent Summary LSAs from being advertised into the NSSA. Use
the no form of the command to return the Summary LSA mode to the
default value.
Syntax
area-id
area stub no-summary
area-id
no area
area-id — Identifies the OSPF area to configure. (Range: IP address or
•
decimal from 0–4294967295)
Default Configuration
Disabled is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example prevents the Summary LSA from being advertised
into the area 3 NSSA.
console(config-router)#area 3 stub no-summary
area virtual-link
Use the area virtual-link command in Router OSPF Configuration mode to
create the OSPF virtual interface for the specified area-id and neighbor
router. To remove the link, use the no form of the command. Use the optional
parameters to configure authentication, dead-interval, hello-interval,
retransmit-interval and transmit-delay. If the area has not been previously
created, it is created by this command. If the area already exists, the virtual-
link information is added or modified.
1206
OSPF Commands
stub no-summary