Dell Networking 2024 Reference Manual page 547

add
Use this command to add member ten gigabit or gigabit Ethernet port(s) or
port channels to the dependency list.
Syntax
add {gigabitethernet | tengigabitethernet | port-channel}
intf-list — List of Ethernet interfaces in unit/slot/port format. Separate
•
nonconsecutive ports with a comma and no spaces. Use a hyphen to
designate the range of ports. (Range: Valid Ethernet interface list or range)
Default Configuration
This command has no default configuration.
Command Mode
Link Dependency mode
User Guidelines
Adding an interface to a dependency list brings the interface down until the
depends-on command is entered. The link status will then follow the
interface specified in the depends-on command.
To avoid bringing down interfaces, enter the depends-on command prior to
entering the add command.
Example
console(config-depend-1)#add gigabitethernet 1/0/1
console(config-depend-1)#add tengigabitethernet 1/0/1
console(config-depend-1)#add port-channel 10-12
depends-on
Use this command to add the dependent Ethernet ports or port channels list.
Use the no depends-on command to remove the dependent Ethernet ports or
port-channels list.
Link Dependency Commands
intf-list
547