Dell Networking 2024 Reference Manual page 378

No monitor capture stops the capture and returns the configuration to the
defaults.
No monitor capture file size returns the capture file size to the defaults.
No monitor capture remote port returns the TCP port to the default.
Syntax
monitor capture [file [size
no monitor capture [file size] [remote port] [line wrap]
max-size —
•
id —
•
The local (switch) TCP port for use with Wireshark.
Default Configuration
Capture is not enabled by default.
The in memory buffer is 128 packets.
The file system buffer is 524288 bytes and is named cpuPktCapture.pcap.
Command Modes
Global Configuration mode
User Guidelines
Only one of file, remote, or line may be specified. Setting the file, remote, or
line stops the capture.
No monitor capture stops the capture and returns the configuration to the
defaults.
No monitor capture file size returns the capture file size to the defaults
No monitor capture remote port returns the TCP port to the default
The administrator can capture packets into one of the following locations:
memory, switch NVRAM, or directly to a Wireshark analyzer.
Memory Capture:
Captured packets can be displayed on the console using the show monitor
capture packets command. Captured packets can be displayed when actively
capturing or when stopped. When a capture session is active, it is possible to
378
Ethernet Configuration Commands
max-size
The size of the capture file in bytes.
] | remote [port
id
] | line [wrap]]