Table of Contents
Advertisement
2.2.4 Wiring the Power Inputs
The 6-contact terminal block connector on the rear panel of IGSW-2840 is used for two DC redundant power input. Please
follow the steps below to insert the power wire.
1.
Insert positive / negative DC power wires into the contacts 1 and 2 for POWER 1, or 5 and 6 for POWER 2.
2.
Tighten the wire-clamp screws for preventing the wires from loosing.
The wire gauge for the terminal block should be in the range between 12 ~ 24 AWG.
Figure 2-9 Wiring the redundant power inputs
1
2
3
DC 1
+
-
Figure 2-10 6-Pin Terminal Block power wiring input
38
User's Manual of IGSW-2840
4
5
6
DC 2
+
-
Advertisement
Chapters
Table of Contents
