Planet IGSW-2840 User Manual page 414

snmp-server group groupname
groupname -Name of an SNMP group. (Range: 1-32 characters)
v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
auth | noauth | priv - This group uses SNMPv3 with authentication, no authentication, or with authentication and privacy.
See "Simple Network Management Protocol" on page 3-39 for further information about these authentication and
encryption options.
readview - Defines the view for read access. (1-64 characters)
writeview - Defines the view for write access. (1-64 characters)
notifyview - Defines the view for notifications. (1-64 characters)
Default Setting
Default groups: public19 (read only), private20 (read/write)
readview - Every object belonging to the Internet OID space (1.3.6.1).
writeview - Nothing is defined.
notifyview -Nothing is defined.
Command Mode
Global Configuration
Command Usage
A group sets the access policy for the assigned users.
When authentication is selected, the MD5 or SHA algorithm is used as specified in the snmp-server user command.
When privacy is selected, the DES 56-bit algorithm is used for data encryption.
For additional information on the notification messages supported by this switch, see "Supported Notification Messages"
on page 3-51. Also, note that the authentication, link-up and link-down messages are legacy traps and must therefore be
enabled in conjunction with the snmp-server enable traps command (page 4-74).
Example
Console(config)#snmp-server group r&d v3 auth write daily
Console(config)#
No view is defined.
Maps to the defaultview.
show snmp group
Four default groups are provided – SNMPv1 read-only access and read/write access, and SNMPv2c read-only access and
read/write access.
Command Mode
Privileged Exec
414
User's Manual of IGSW-2840