Planet IGSW-2840 User Manual page 383

stopbits
This command sets the number of the stop bits transmitted per byte. Use the no form to restore the default setting.
Syntax
stopbits {1 | 2}
1 - One stop bit
2 - Two stop bits
Default Setting
1 stop bit
Command Mode
Line Configuration
Example
To specify 2 stop bits, enter this command:
Console(config-line)#stopbits 2
Console(config-line)#
disconnect
This command terminates an SSH, Telnet, or console connection.
Syntax
disconnect session-id
session-id – The session identifier for an SSH, Telnet or console
connection. (Range: 0-4)
Command Mode
Privileged Exec
Command Usage
Specifying session identifier "0" will disconnect the console connection. Specifying any other identifiers for an active
session will disconnect an SSH or Telnet connection.
Example
Console#disconnect 1
Console#
Related Commands
show ssh
show users
show line
This command displays the terminal line's parameters.
383
User's Manual of IGSW-2840