Planet IGSW-2840 User Manual page 401

Example
Console(config)#cluster commander
Console(config)#
cluster ip-pool
This command sets the cluster IP address pool. Use the no form to reset to the default address.
Syntax
cluster ip-pool ip-address no cluster ip-pool
ip-address - The base IP address for IP addresses assigned to cluster Members. The IP address must start 10.x.x.x.
Default Setting
10.254.254.1
Command Mode
Global Configuration
Command Usage
An "internal" IP address pool is used to assign IP addresses to Member switches in the cluster. Internal cluster IP
addresses are in the form 10.x.x.member-ID. Only the base IP address of the pool needs to be set since Member IDs can
only be between 1 and 36.
Set a Cluster IP Pool that does not conflict with addresses in the network IP subnet. Cluster IP addresses are assigned to
switches when they become Members and are used for communication between Member switches and the Commander.
You cannot change the cluster IP pool when the switch is currently in Commander mode. Commander mode must first be
disabled.
Example
Console(config)#cluster ip-pool 10.2.3.4
Console(config)#
cluster member
This command configures a Candidate switch as a cluster Member. Use the no form to remove a Member switch from the
cluster.
Syntax
cluster member mac-address mac-address id member-id no cluster member id member-id
mac-address - The MAC address of the Candidate switch.
member-id - The ID number to assign to the Member switch. (Range: 1-36)
Default Setting
No Members
401
User's Manual of IGSW-2840