Line Commands - Planet IGSW-2840 User Manual

5.6 Line Commands

You can access the onboard configuration program by attaching a VT100 compatible device to the server's serial port. These
commands are used to set communication parameters for the serial port or Telnet (i.e., a virtual terminal).
Command
line
login
password
timeout login response
exec-timeout
password-thresh
silent-time*
databits*
parity*
speed*
stopbits*
disconnect
show line
* These commands only apply to the serial port.
line
This command identifies a specific line for configuration, and to process subsequent line configuration commands.
Syntax
line {console | vty}
console -Console terminal line.
vty - Virtual terminal for remote console access (i.e., Telnet).
Default Setting
Function
Identifies a specific line for configuration and starts the
lineconfiguration mode
Enables password checking at login
Specifies a password on a line
Sets the interval that the system waits for a user to log into the
CLI
Sets the interval that the command interpreter waits until
userinput is detected
Sets the password intrusion threshold, which limits the number
of failed logon attempts
Sets the amount of time the management console is
inaccessible after the number of unsuccessful logon
attemptsexceeds the threshold set by the password-thresh
command
Sets the number of data bits per character that are interpreted
and generated by hardware
Defines the generation of a parity bit
Sets the terminal baud rate
Sets the number of the stop bits transmitted per byte
Terminates a line connection
Displays a terminal line's parameters
Table 5-13 Line Commands
376
User's Manual of IGSW-2840
Mode
GC
LC
LC
LC
LC
LC
LC
LC
LC
LC
LC
PE
NE, PE