Planet IGSW-2840 User Manual page 499

Default Setting
None
Command Mode
Global Configuration
Command Usage
When you create a new ACL or enter configuration mode for an existing ACL, use the permit or deny command to add
new rules to the bottom of the list. To create an ACL, you must add at least one rule to the list.
To remove a rule, use the no permit or no deny command followed by the exact text of a previously configured rule.
An ACL can contain up to 100 rules.
Example
Console(config)#access-list mac jerry
Console(config-mac-acl)#
Related Commands
permit, deny
mac access-group
show mac access-list
permit, deny (MAC ACL)
This command adds a rule to a MAC ACL. The rule filters packets matching a specified MAC source or destination address (i.e.,
physical layer address), or Ethernet protocol type. Use the no form to remove a rule.
Syntax
[no]{permit | deny} {any | host source | source address-bitmask} {any | host destination | destination address-bitmask} [cos
cos-value] [vid vid vid-bitmask] [ethertype protocol]
The default is for Ethernet II packets.
[no]{permit | deny} eth2
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
[cos cos-value] [vid vid vid-bitmask] [ethertype protocol]
[no]{permit | deny} 802.3
{any | host source | source address-bitmask}
{any | host destination | destination address-bitmask}
499
User's Manual of IGSW-2840