Planet IGSW-2840 User Manual page 522

Syntax
lacp {actor | partner} admin-key key
[no] lacp {actor | partner} admin-key
key -The port channel admin key is used to identify a specific link aggregation group (LAG) during local LACP setup on
this switch. (Range: 0-65535)
Default Setting
0
Command Mode
Interface Configuration (Port Channel)
Command Usage
Ports are only allowed to join the same LAG if (1) the LACP system priority matches, (2) the LACP port admin key
matches, and (3) the LACP port channel key matches (if configured).
If the port channel admin key (lacp admin key - Port Channel) is not set when a channel group is formed (i.e., it has the
null value of 0), this key is set to the same value as the port admin key (lacp admin key - Ethernet Interface) used by the
interfaces that joined the group. Note that when the LAG is no longer used, the port channel admin key is reset to 0.
Example
Console(config)#interface port-channel 1
Console(config-if)#lacp actor admin-key 3
Console(config-if)#
lacp port-priority
This command configures LACP port priority. Use the no form to restore the
Syntax
lacp {actor | partner} port-priority priority
no lacp {actor | partner} port-priority
actor - The local side an aggregate link.
partner - The remote side of an aggregate link.
priority - LACP port priority is used to select a backup link.
(Range: 0-65535)
Default Setting
32768
Command Mode
Interface Configuration (Ethernet)
Command Usage
Setting a lower value indicates a higher effective priority.
If an active port link goes down, the backup port with the highest priority is selected to replace the downed link. However, if
two or more ports have the same LACP port priority, the port with the lowest physical port number will be selected as the
Default Setting
522
User's Manual of IGSW-2840
.