Ip Interface Commands - Planet IGSW-2840 User Manual

5.26 IP Interface Commands

An IP addresses may be used for management access to the switch over your network. The IP address for this switch is
obtained via DHCP by default. You can manually configure a specific IP address, or direct the device to obtain an address from
a BOOTP or DHCP server. You may also need to a establish a default gateway between this device and management stations
that exist on another network segment.
Command
ip address
ip default-gateway
ip dhcp restart
show ip interface
show ip redirects
ping
ip address
This command sets the IP address for the currently selected VLAN interface. Use the no form to restore the default IP address.
Syntax
ip address {ip-address netmask | bootp | dhcp} no ip address
ip-address -IP address
netmask - Network mask for the associated IP subnet. This mask identifies the host address bits used for routing to
specific subnets.
bootp - Obtains IP address from BOOTP.
dhcp - Obtains IP address from DHCP.
Default Setting
DHCP
Command Mode
Interface Configuration (VLAN)
Command Usage
You must assign an IP address to this device to gain management access over the network. You can manually configure a
specific IP address, or direct the device to obtain an address from a BOOTP or DHCP server. Valid IP addresses consist
of four numbers, 0 to 255, separated by periods. Anything outside this format will not be accepted by the configuration
program.
If you select the bootp or dhcp option, IP is enabled but will not function until a BOOTP or DHCP reply has been received.
Function
Sets the IP address for the current interface
Defines the default gateway through which this switch can
reach other subnetworks
Submits a BOOTP or DHCP client request
Displays the IP settings for this device
Displays the default gateway configured for this device
Sends ICMP echo request packets to another node on
thenetwork
Table 5-93 IP Interface Commands
653
User's Manual of IGSW-2840
Mode
IC
GC
PE
PE
PE
NE, PE