Planet IGSW-2840 User Manual page 512

specified using the broadcast byte-rate command, applies to all ports on the switch.
Example
The following shows how to enable broadcast storm control for port 5.
Console(config)#interface ethernet 1/5
Console(config-if)#switchport broadcast
Console(config-if)#
clear counters
This command clears statistics on an interface.
Syntax
clear counters interface interface
• ethernet unit/port
-unit - Stack unit. (Range: 1)
-port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-12)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Statistics are only initialized for a power reset. This command sets the base value for displayed statistics to zero for the
current management session. However, if you log out and back into the management interface, the statistics displayed will
show the absolute value accumulated since the last power reset.
Example
Example
The following
Console#clear counters ethernet 1/5
Console#
show interfaces status
This command displays the status for an interface.
Syntax
show interfaces status [interface] interface
ethernet unit/port
-unit - Stack unit. (Range: 1)
clears statistics on port 5.
512
User's Manual of IGSW-2840