Planet IGSW-2840 User Manual page 583

Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan auto
Console(config-if)#
switchport voice vlan rule
This command selects a method for detecting VoIP traffic on a port. Use the no form to disable the selected detection method
on a port.
Syntax
[no] switchport voice vlan rule {oui | lldp}
• oui - Traffic from VoIP devices is detected by the Organizationally Unique Identifier (OUI) of the source MAC address.
• lldp - Uses LLDP to discover VoIP devices attached to the port.
Default Setting
OUI: Enabled
LLDP: Disabled
Command Mode
Interface Configuration
Command Usage
• When OUI is selected, be sure to configure the MAC address ranges in the Telephony OUI list (see the voice vlan
mac-address command). MAC address OUI numbers must be configured in the Telephony OUI list so that the switch
recognizes the traffic as being from a VoIP device.
• LLDP checks that the "telephone bit" in the system capability TLV is turned on. See "LLDP Commands" for more
information on LLDP.
Example
The following example enables the OUI method on port 1 for detecting VoIP traffic.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan rule oui
Console(config-if)#
switchport voice vlan security
This command enables security filtering for VoIP traffic on a port. Use the no form to disable filtering on a port.
Syntax
[no] switchport voice vlan security
4-251
583
User's Manual of IGSW-2840