Wiring The Fault Alarm Contact - Planet IGSW-2840 User Manual

User's Manual of IGSW-2840

2.2.5 Wiring the Fault Alarm Contact

The fault alarm contacts are in the middle of the terminal block connector as the picture shows below. Inserting the wires, the
Industrial Switch will detect the fault status of the power failure. The following illustration shows an application example for
wiring the fault alarm contacts.
1. Insert the wires into the fault alarm contacts
Figure 2-11 Power Fault Alarm trigger description
The wire gauge for the terminal block should be in the range between 12 ~ 24 AWG.
39