Planet IGSW-2840 User Manual page 577

Command Mode
Global Configuration
Example
The following creates protocol group 1, and specifies the IPX protocol type. Protocol VLAN group 2 is created with
protocol-type IPv6 (86DD) and frame-type ethernet specified:
Console(config)#protocol-vlan protocol-group 1 add protocol-type ipx
Console(config)#protocol-vlan protocol-group 2 add protocol-type 86dd
frame-type ethernet
Console(config)#
protocol-vlan protocol-group
This command maps a protocol group to a VLAN for the current interface. Use the no form to remove the protocol mapping for
this interface.
Syntax
protocol-vlan protocol-group group-id vlan vlan-id
no protocol-vlan protocol-group group-id vlan
• group-id - Group identifier of this protocol group. (Range: 1-2147483647)
• vlan-id -VLAN to which matching protocol traffic is forwarded. (Range: 1-4094)
Default Setting
No protocol groups are mapped for any interface.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• When creating a protocol-based VLAN, only assign interfaces via this command. If you assign interfaces using any of
the other VLAN commands (such as the vlan command on page 4-226), these interfaces will admit traffic of any
protocol type into the associated VLAN.
• A maximum of 20 protocol VLAN groups can be defined on the switch. A maximum of 5 protocol VLAN groups can be
mapped to any interface.
• When a frame enters a port that has been assigned to a protocol VLAN, it is processed in the following manner:
-If the frame is tagged, it will be processed according to the standard rules applied to tagged frames.
-If the frame is untagged and the protocol type matches, the frame is forwarded to the appropriate VLAN.
-If the frame is untagged but the protocol type does not match, the frame is forwarded to the default VLAN for this
interface.
Example
The following example maps the traffic entering Port 1 which matches the protocol type specified in protocol group 1 to
(Configuring Interfaces)
577
User's Manual of IGSW-2840