Planet IGSW-2840 User Manual page 374

boot-rom - Boot ROM (or diagnostic) image file.
config -Switch configuration file. opcode - Run-time operation code image file.
filename -Name of the configuration file or code image.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
If you enter the command dir without any parameters, the system displays all files.
File information is shown below:
Command Group
file name
file type
startup
size
Example
The following example shows how to display all file information:
Console#dir File name File type Startup Size (byte) ------------------------------------- ---------------------
----------Unit1: IGSW-2840_DIAG_V0011.bix Boot-Rom Image Y 305424
IGSW-2840_RUNTIME_V0035_m.bix Operation Code Y 3018936
Factory_Default_Config.cfg Config File N 490 startup1.cfg Config File Y 4648
--------------------------------------------------------------------------
Console#
whichboot
This command displays which files were booted when the system powered up.
Command Mode
Privileged Exec
Example
This example shows the information displayed by the whichboot command. See the table under the dir command for a
description of the file information displayed by this command.
Description
The name of the file.
File types: Boot-Rom, Operation Code, and Config file.
Shows if this file is used when the system is started.
The length of the file in bytes.
Table 5-12 File Directory Information
Total free space: 3276800
374
User's Manual of IGSW-2840