Planet IGSW-2840 User Manual page 638

Example
The following shows how to configure the default timeout to 300 seconds:
Console(config)#ip igmp snooping router-port-expire-time 300
Console(config)#
Related Commands
ip igmp snooping version
5.25.3 Static Multicast Routing Commands
This section describes commands used to configure static multicast routing on the switch.
Command
ip igmp snooping vlan mrouter
show ip igmp snooping mrouter
ip igmp snooping vlan mrouter
This command statically configures a multicast router port. Use the no form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
vlan-id -VLAN ID (Range: 1-4094)
interface
ethernet unit/port
-unit - Stack unit. (Range: 1)
-port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-12)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
Depending on your network connections, IGMP snooping may not always be able to locate the IGMP querier. Therefore, if
the IGMP querier is a known multicast router/switch connected over the network to an interface (port or trunk) on your
router, you can manually configure that interface to join all the current multicast groups.
Example
The following shows how to configure port 11 as a multicast router port within VLAN 1:
Console(config)#ip igmp snooping vlan 1 mrouter ethernet 1/11
Console(config)#
Function
Adds a multicast router port
Shows multicast router ports
Table 5-87 Static Multicast Routing Commands
638
User's Manual of IGSW-2840
Mode
GC
PE