Planet IGSW-2840 User Manual page 497

Related Commands
ip access-group
map access-list ip
This command sets the output queue for packets matching an ACL rule. The specified CoS value is only used to map the
matching packet to an output queue; it is not written to the packet itself. Use the no form to remove the CoS mapping.
Syntax
[no] map access-list ip acl_name cos cos-value
acl_name – Name of the ACL. (Maximum length: 16 characters)
cos-value – CoS value. (Range: 0-7)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
You must configure an ACL before you can map CoS values to the rule.
A packet matching a rule within the specified ACL is mapped to one of the output queues as shown in the following table.
For information on mapping the CoS values to output queues, see
Example
Console(config)# interface ethernet 1/2
Console(config-if)#map access-list ip bill cos 0
Console(config-if)
Related Commands
queue cos-map
show map access-list ip
show map access-list ip
This command shows the CoS value mapped to an IP ACL for the current interface. (The CoS value determines the output
queue for packets matching an ACL rule.)
Syntax
Priority 1,2
Queue 0
Table 5-48 Egress Queue Priority Mapping
queue cos-map.
0,3 4,5
1 2
497
User's Manual of IGSW-2840
6,7
3