Planet IGSW-2840 User Manual page 516

Private-VLAN Mapping: NONE
802.1Q-tunnel Status: Disable
802.1Q-tunnel Mode: NORMAL
802.1Q-tunnel TPID: 8100(Hex)
Console#
Field
Broadcast Threshold
LACP Status
Ingress Rate Limit
Egress Rate Limit
VLAN Membership Mode
Ingress Rule
Acceptable Frame Type
Native VLAN
Priority for UntaggedTraffic
GVRP Status
Allowed VLAN
Forbidden VLAN
Private VLAN Mode
Private VLAN
Host-association
Private VLAN Mapping
802.1Q-tunnel Status
802.1Q-tunnel Mode
802.1Q-tunnel TPID
Description
Shows if broadcast storm suppression is enabled or disabled; if
enabled it also shows the threshold level
Shows if Link Aggregation Control Protocol has been enabled or
disabled
Shows if ingress rate limiting is enabled, and the current rate limit.
Shows if egress rate limiting is enabled, and the current rate limit.
Indicates membership mode as Trunk or Hybrid
Shows if ingress filtering is enabled or disabled. Note: Ingress
filtering is always enabled.
Shows if acceptable VLAN frames include all types or tagged
frames only
Indicates the default Port VLAN ID.
Indicates the default priority for untagged frames
Shows if GARP VLAN Registration Protocol is enabled or disabled
Shows the VLANs this interface has joined, where "(u)" indicates
untagged and "(t)" indicates tagged
Shows the VLANs this interface can not dynamically join via GVRP
Shows the private VLAN mode as host, promiscuous, or none
Shows the secondary (or community) VLAN with which this port is
associated
Shows the primary VLAN mapping for a promiscuous port
Shows if 802.1Q tunnel is enabled on this interface
Shows the tunnel mode as Normal, 802.1Q Tunnel or 802.1Q
Tunnel Uplink
Shows the Tag Protocol Identifier used for learning and switching
packets
Table 5-53 Interfaces Switchport Statistics
516
User's Manual of IGSW-2840