Planet IGSW-2840 User Manual page 287

Re-authentication
Max-Request
Quiet Period
Re-authentication Period
Tx Period
Intrusion Action
Authorized
Supplicant
Trunk
-Force-Unauthorized Forces the port to deny access to all clients, either
dot1x-aware or otherwise.
Sets the client to be re-authenticated after the interval specified by the
Re-authentication Period. Re-authentication can be used to detect if a new
device is plugged into a switch port.
(Default: Disabled)
Sets the maximum number of times the switch port will retransmit an EAP
request packet to the client before it times out the authentication session.
(Range: 1-10; Default 2)
Sets the time that a switch port waits after the Max Request Count has been
exceeded before attempting to acquire a new client.
Range: 1-65535 seconds
Default: 60 seconds
Sets the time period after which a connected client must be re-authenticated.
Range: 1-65535 seconds
Default: 3600 seconds
Sets the time period during an authentication session that the switch waits before
re-transmitting an EAP packet.
Range: 1-65535;
Default: 30 seconds
Sets the port's response to a failed authentication.
-Block Traffic Blocks all non-EAP traffic on the port. (This is the default
setting.)
-Guest VLAN All traffic for the port is assigned to a guest VLAN. The guest
VLAN must be separately configured (See "Creating VLANs") and mapped on
each port (See "Configuring MAC Authentication for Ports").
Displays the 802.1X authorization status of connected clients.
-Yes Connected client is authorized.
-No Connected client is not authorized.
-Blank Displays nothing when dot1x is disabled on a port.
Indicates the MAC address of a connected client.
Indicates if the port is configured as a trunk port.
287
User's Manual of IGSW-2840