Snmp Commands - Planet IGSW-2840 User Manual

5.11 SNMP Commands

Controls access to this switch from management stations using the Simple Network Management Protocol (SNMP), as well as
the error types sent to trap managers.
SNMP Version 3 also provides security features that cover message integrity, authentication, and encryption; as well as
controlling user access to specific areas of the MIB tree. To use SNMPv3, first set an SNMP engine ID (or accept the default),
specify read and write access views for the MIB tree, configure SNMP user groups with the required security model (i.e., SNMP
v1, v2c or v3) and security level (i.e., authentication and privacy), and then assign SNMP users to these groups, along with their
specific authentication and privacy passwords.
Command
snmp-server
show snmp
snmp-server community
snmp-server contact
snmp-server location
snmp-server host
snmp-server enable traps
snmp-server engine-id
show snmp engine-id
snmp-server view
show snmp view
snmp-server group
show snmp group
snmp-server user
show snmp user
snmp-server
This command enables the SNMPv3 engine and services for all management clients (i.e., versions 1, 2c, 3). Use the no form to
disable the server.
Syntax
[no] snmp-server
Default Setting
Enabled
Command Mode
Global Configuration
Function
Enables the SNMPv3 server
Displays the status of SNMP communications
Sets up the community access string to permit access to SNMP
commands
Sets the system contact string
Sets the system location string
Specifies the recipient of an SNMP notification operation
Enables the device to send SNMP traps (i.e.,
SNMPnotifications)
Sets the SNMPv3 engine ID
Shows the SNMPv3 engine ID
Adds an SNMPv3 view
Shows the SNMPv3 views
Adds an SNMPv3 group, mapping users to views
Shows the SNMPv3 groups
Adds a user to an SNMPv3 group
Shows the SNMPv3 users
Table 5-21 SNMP Command
404
User's Manual of IGSW-2840
Mode
GC
NE, PE
GC
GC
GC
GC
GC
GC
PE
GC
PE
GC
PE
GC
PE