Planet IGSW-2840 User Manual page 491

Command Grup
IP ACLs
MAC ACLs
ACL Information
5.14.1 IP ACLs
The commands in this section configure ACLs based on IP addresses, TCP/UDP port number, protocol type, and TCP control
code. To configure IP ACLs, first create an access list containing the required permit or deny rules, and then bind the access list
to one or more ports.
Command
access-list ip
permit, deny
permit, deny
show ip access-list
ip access-group
show ip access-group
map access-list ip
show map access-list ip
access-list ip
This command adds an IP access list and enters configuration mode for standard or extended IP ACLs. Use the no form to
remove the specified ACL.
Syntax
[no] access-list ip {standard | extended} acl_name
• standard – Specifies an ACL that filters packets based on the source IP address.
• extended – Specifies an ACL that filters packets based on the source or destination IP address, and other more
specific criteria.
Function
Configures ACLs based on IP addresses, TCP/UDP port
number, andprotocol type
Configures ACLs based on hardware addresses, packet format,
and Ethernet type
Displays ACLs and associated rules; shows ACLs assigned to
each port
Table 5-46 Access Control Lists
Function
Creates an IP ACL and enters configuration mode for standard
or extended IP ACLs
Filters packets matching a specified source IP address
Filters packets meeting the specified criteria, including source
and destination IP address, TCP/UDP port number, protocol
type, and TCP control code
Displays the rules for configured IP ACLs
Adds a port to an IP ACL
Shows port assignments for IP ACLs
Sets the CoS value and corresponding output queue for packets
matching an ACL rule
Shows CoS value mapped to an access list for an interface
Table 5-47 IP ACL Commands
491
User's Manual of IGSW-2840
Mode
GC
STD-ACL
EXT-ACL
PE
IC
PE
IC
PE