Planet IGSW-2840 User Manual page 417

Global Configuration
Command Usage
The SNMP engine ID is used to compute the authentication/privacy digests from the password. You should therefore
configure the engine ID with the snmp-server engine-id command before using this configuration command.
Before you configure a remote user, use the snmp-server engine-id command (page 4-75) to specify the engine ID for the
remote device where the user resides. Then use the snmp-server user command to specify the user and the IP address
for the remote device where the user resides. The remote agent's SNMP engine ID is used to compute
authentication/privacy digests from the user's password. If the remote engine ID is not first configured, the snmp-server
user command specifying a remote user will fail.
SNMP passwords are localized using the engine ID of the authoritative agent. For informs, the authoritative SNMP agent
is the remote agent. You therefore need to configure the remote agent's SNMP engine ID before you can send proxy
requests or informs to it.
Example
Console(config)#snmp-server user steve group r&d v3 auth md5 greenpeace
priv des56 einstien
Console(config)#snmp-server user mark group r&d remote 192.168.1.19 v3
auth md5 greenpeace priv des56 einstien
Console(config)#
show snmp user
This command shows information on SNMP users.
Command Mode
Privileged Exec
Example
Console#show snmp user
EngineId: 800000ca030030f1df9ca00000
User Name: steve
Authentication Protocol: md5
Privacy Protocol: des56
Storage Type: nonvolatile
Row Status: active
SNMP remote user
417
User's Manual of IGSW-2840