Connecting The Srx 210 Services Gateway; Chapter 8 Connecting The Srx 210 Services Gateway Required Tools And Parts For Connecting The Srx 210 Services Gateway - Juniper SRX 210 Services Hardware Manual

Chapter 8
Connecting the SRX 210 Services
Gateway
Required Tools and Parts for Connecting the SRX 210 Services Gateway
Related Topics
Connecting the SRX 210 Services Gateway to the Power Supply
This section includes the following topics:
Required Tools and Parts for Connecting the SRX 210 Services
Gateway on page 67
Connecting the SRX 210 Services Gateway to the Power Supply on page 67
Connecting Interface Cables to the SRX 210 Services Gateway on page 69
Organizing Interface Cables on the SRX 210 Services Gateway on page 69
To connect the services gateway, you need the following tools and parts:
Electrostatic discharge (ESD) grounding wrist strap
Removing and Installing Mini-Physical Interface Modules in the SRX 210 Services
Gateway on page 66
Connecting the SRX 210 Services Gateway to the Power Supply on page 67
To connect the device to the power supply:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
1.
connect the strap to the ESD point on the chassis.
Plug the DC connector end of the power cable into the power connector on the
2.
back of the device (see Figure 13 on page 68).
Plug the AC adapter end of the power cable into an AC power outlet.
3.
Required Tools and Parts for Connecting the SRX 210 Services Gateway
67