Step 2: Install The Mounting Hardware; Install The Mounting Hardware In A Four-Post Rack Or Cabinet Or An Open-Frame Rack - Juniper SRX 5600 Getting Started Manual

SRX 5600 Services Gateway Getting Started Guide

Step 2: Install the Mounting Hardware

To install the mounting hardware in a four-post rack or cabinet or an open-frame
rack:

Install the Mounting Hardware in a Four-Post Rack or Cabinet or an Open-Frame Rack

To install the mounting shelf on the front rails of a four-post rack or cabinet, or the
rails of an open-frame rack:
1.
2.
3.
4.
5.
Table 2: Mounting Hole Locations
6
Step 2: Install the Mounting Hardware
Install the Mounting Hardware in a Four-Post Rack or Cabinet or an Open-Frame
Rack on page 6
If needed, install cage nuts in the holes specified in Table 2 on page 6.
On the back of each rack rail, partially insert a mounting screw into the lowest
hole specified in Table 2 on page 6.
Install the mounting shelf on the back of the rack rails. Rest the bottom slot of
each flange on a mounting screw.
Partially insert screws into the open holes in each flange of the mounting shelf
(see Figure 2 on page 7 or Figure 3 on page 8).
Tighten all the screws completely.
Hole Distance Above U" Division
4 2.00 in. (5.1 cm)
3 1.51 in. (3.8 cm)
2 0.88 in. (2.2 cm)
1 0.25 in. (0.6 cm)
Mounting Shelf
1.14 U
X
0.86 U
X
0.50 U
X
0.14 U
X