Step 2: Install The Mounting Hardware In A Four-Post Rack Or Cabinet Or An Open-Frame Rack - Juniper SRX5600 Getting Started Manual

SRX5600 Services Gateway Getting Started Guide
Tools Required to Unpack and Prepare the SRX5600 Services Gateway for Installation
Step 2: Install the Mounting Hardware in a Four-Post Rack or Cabinet or an Open-Frame
Rack
6
To unpack the services gateway and prepare for installation, you need the following
tools:
A mechanical lift—recommended
Phillips (+) screwdrivers, numbers 1 and 2
2.5-mm flat-blade (–) screwdriver
7/16-in. torque-controlled driver or socket wrench
1/2-in. or 13-mm open-end or socket wrench to remove bracket bolts from the shipping
pallet
Electrostatic discharge wrist strap
Antistatic mat
Proceed to "Step 2: Install the Mounting Hardware in a Four-Post Rack or Cabinet or an
Open-Frame Rack" on page
To install the mounting shelf on the front rails of a four-post rack or cabinet, or on the
rails of an open-frame rack:
If needed, install cage nuts in the holes specified in
1.
On the back of each rack rail, partially insert a mounting screw into the lowest hole
2.
specified in Table 2 on page
Install the mounting shelf on the back of the rack rails. Rest the bottom slot of each
3.
flange on a mounting screw.
Partially insert screws into the open holes in each flange of the mounting shelf (see
4.
Figure 2 on page 7 or Figure 3 on page
Tighten all the screws completely.
5.
Table 2: Mounting Shelf Hole Locations
Hole (Starting from U
Division)
4
3
2
1
6.
6.
8).
Distance Above U Division
2.00 in. (5.1 cm)
1.51 in. (3.8 cm)
0.88 in. (2.2 cm)
0.25 in. (0.6 cm)
Table 2 on page 6.
1.14 U
0.86 U
0.50 U
0.14 U
Copyright © 2013, Juniper Networks, Inc.